200-105 Exam PDF Questions

By | January 3, 2020

The 200-105 exam tests your abilities related to LAN switching technologies, IPv4 and IPv6 routing technologies, WAN technologies, infrastructure services, and infrastructure maintenance.

Try it Latest DumpsSchool 200-105 Exam dumps. Buy Full File here: https://www.dumpsschool.com/200-105-exam-dumps.html (691 As Dumps)

Download the DumpsSchool 200-105 braindumps from Google Drive: https://drive.google.com/file/d/1TwCxP9R2WPXn5O77CUBND73niqczpZDp/view (FREE VERSION!!!)

Question No. 1

What can be done to Frame Relay to resolve split-horizon issues?(Choose two.)

Answer: B, D

IP split horizon checking is disabled by default for Frame Relay encapsulation to allow routing updates to go in and out of the same interface. An exception is the Enhanced Interior Gateway Routing Protocol (EIGRP) for which split horizon must be explicitly disabled.

Certain protocols such as AppleTalk, transparent bridging, and Internetwork Packet Exchange (IPX) cannot be supported on partially meshed networks because they require split horizon to be enabled (a packet received on an interface cannot be transmitted over the same interface, even if the packet is received and transmitted on different virtual circuits).

Configuring Frame Relay subinterfaces ensures that a single physical interface is treated as multiple virtual interfaces. This capability allows you to overcome split horizon rules so packets received on one virtual interface can be forwarded to another virtual interface, even if they are configured on the same physical interface.

Question No. 2

Which of the port is not part of STP protocol?

Answer: D

Question No. 3

Which command do you enter to verify that a VLAN has been removed from a trunk?

Answer: A

Question No. 4

Which port type is used in a stacked deployment?

Answer: A

Question No. 5

Which type of VPN allows for one endpoint to be learned dynamically during tunnel negotiation?

Answer: A

Question No. 6

A router has been configured to provide the nine users on the branch office LAN with Internet access, as

shown in the diagram. It is found that some of the users on the LAN cannot reach the Internet.

Based on the topology and router output shown, which command should be issued on the router to correct the

problem?

Answer: D

Question No. 7

SIMULATION

Lab Simulation Question: 300

CCNA.com has a small network that is using EIGRP as its IGP. All routers should be running an EIGRP AS

number 12. Router MGT is also running static routing to the ISP.

CCNA.com has recently adding the ENG router. Currently, the ENG router does not have connectivity to the

ISP router. All other interconnectivity and Internet access for the existing locations of the company are working

properly.

The task is to identify the fault(s) and correct the router configuration(s) to provide full connectivity between

the routers.

Access to the router CLI can be gained by clicking on the appropriate host.

All passwords on all routers are cisco.

IP addresses are listed in the chart below.

MGT

Fa0/0-192.168.77.33

S1/0-198.0.18.6

S0/0-192.168.27.9

S0/1-192.168.50.21

ENG

Fa0/0-192.168.77.34

Fa1/0-192.168.12.17

Fa0/1-192.168.12.1

Parts1

Fa0/0-192.168.12.33

Fa0/1-192.168.12.49

S0/0-192.168.27.10

Parts2

Fa0/0-192.168.12.65

Fa0/1-192.168.12.81

S0/1-192.168.50.22

Answer: A

Question No. 8

In an HSRP failover environment, which two tasks must you perform on the preferred active router so that it

always assumes the active role when it comes up? (Choose two.)

Answer: A, C

Question No. 9

What is the alert message generated by SNMP agents called? (Choose two.)

Answer: A, B

Question No. 10

Which command must you enter to enable OSPFV2 in an IPV4 network?

Answer: D

Question No. 11

Which Cisco IOS feature can you use to dynamically identify a connectivity problem between a Cisco device

and a designated endpoint?

Answer: B

Question No. 12

Which utility do you use to view IP traffic that is switched through the router to locate errors in a TCP stream?

Answer: B

Cisco routers provide a basic method of viewing IP traffic switched through the router called packet debugging.

Packet debugging enables a user to determine whether traffic is travelling along an expected path in the

network or whether there are errors in a particular TCP stream. Although in some cases packet debugging can

eliminate the need for a packet analyzer, it should not be considered a replacement for this important tool.

https://www.cisco.com/en/US/docs/internetworking/troubleshooting/guide/tr1907.html

Question No. 13

Which two types of cloud services may require you to alter the design of your network infrastructure? (Choose

two.)

Answer: B, C

Question No. 14

Which three options are types of Layer 2 network attack? (Choose three)

Answer: A, C, E

200-105 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1TwCxP9R2WPXn5O77CUBND73niqczpZDp/view

Related Certification: CCNA Routing & Switching dumps

Leave a Reply

Your email address will not be published. Required fields are marked *