Cisco 300-115 Exam Preparation Questions – Pass With Guarantee

By | January 19, 2018

Cisco Implementing Cisco IP Switched Networks 300-115 exam preparation is now reachable without spending huge amount of money and time because the most authenticated comprehensive Cisco 300-115 exam dumps materials are available on 25% discounted price for ensured success. Cisco Certified Network Professional Routing and Switching 300-115 exam Practice test software enables you to practice for Cisco 300-115 exam with real exam scenarios to boost your confidence and to enable you attempt the Cisco exam with full confidence to pass.

♥♥ 2018 NEW RECOMMEND 300-115 Exam Questions ♥♥

300-115 exam questions, 300-115 PDF dumps; 300-115 exam dumps:: https://www.dumpsschool.com/300-115-exam-dumps.html (364 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-115 Dumps Exam Questions and Answers:

Question: 21

A network engineer must adjust the STP interface attributes to influence root port selection. Which two elements are used to accomplish this? (Choose two.)

A. port-priority
B. cost
C. forward-timers
D. link type
E. root guard

Answer: A,B

Question: 22

A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?

A. Configure the new load balancing method using port-channel load-balance.
B. Adjust the switch SDM back to “default”.
C. Ensure that IP CEF is enabled globally to support all load balancing methods.
D. Upgrade the PFC to support the latest load balancing methods.

Answer: A

Question: 23

What percentage of bandwidth is reduced when a stack cable is broken?

A. 0
B. 25
C. 50
D. 75
E. 100

Answer: C

Question: 24

Refer to the exhibit.

Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?

A. switch1 channel-group 1 mode active switch2 channel-group 1 mode auto
B. switch1 channel-group 1 mode desirable switch2 channel-group 1 mode passive
C. switch1 channel-group 1 mode on switch2 channel-group 1 mode auto
D. switch1 channel-group 1 mode desirable switch2 channel-group 1 mode auto

Answer: D

Question: 25

Refer to the exhibit.

How can the traffic that is mirrored out the GigabitEthernet0/48 port be limited to only traffic that is received or transmitted in VLAN 10 on the GigabitEthernet0/1 port?

A. Change the configuration for GigabitEthernet0/48 so that it is a member of VLAN 10.
B. Add an access list to GigabitEthernet0/48 to filter out traffic that is not in VLAN 10.
C. Apply the monitor session filter globally to allow only traffic from VLAN 10.
D. Change the monitor session source to VLAN 10 instead of the physical interface.

Answer: C

Question: 26

Refer to the exhibit.

A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be configured to mirror traffic to a packet sniffer that is connected to the distribution switch? (Choose three.)

A. A monitor session on the distribution switch with a physical interface as the source and the remote SPAN VLAN as the destination
B. A remote SPAN VLAN on the distribution and access layer switch
C. A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destination
D. A monitor session on the distribution switch with a remote SPAN VLAN as the source and physical interface as the destination
E. A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destination
F. A monitor session on the distribution switch with a physical interface as the source and a physical interface as the destination

Answer: B,C,D

New Updated 300-115 Exam Questions 300-115 PDF dumps 300-115 practice exam dumps: https://www.dumpsschool.com/300-115-exam-dumps.html