Cisco 300-370 Exam Preparation Questions – Pass With Guarantee

By | January 3, 2018

Cisco Troubleshooting Cisco Wireless Enterprise Networks 300-370 exam preparation is now reachable without spending the huge amount of money and time because the most authenticated comprehensive Cisco 300-370 exam dumps materials are available on 25% discounted price for ensured success. Cisco Certified Network Professional Wireless 300-370 exam Practice test software enables you to practice for Cisco 300-370 exam with real exam scenarios to boost your confidence and to enable you to attempt the Cisco exam with full confidence to pass.

300-370 exam questions, 300-370 PDF dumps; 300-370 exam dumps:: https://www.dumpsschool.com/300-370-exam-dumps.html (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-370 Dumps Exam Questions and Answers:

Version 8.0
Question: 21

A company consists of two adjacent buildings, each with its own Cisco 5508 Wireless Controller with APs joined to the controller in the building. The two controllers are configured identically except for interface IP addresses. Only one SSID is being used in both buildings. The clients in building A are not experiencing any connectivity issues, but (he clients in building B report poor connections An engineer performs a site survey and finds co-channel interference, yet discovers mac Transmit Power Control was never performed on the APs and that Radio Resource Management is not functioning like it does in building A Furthermore, the controllers are in the same RF group and controller A is elected RF leader Which action will improve client connections in building B?

A. Ensure WMM is enabled on the SSID
B. Manually select controller B as RF group leader.
C. Configure controller B to be in a separate RF group.
D. Doable the low data rates on the radio and the b/g radio in building B.

Answer: C

Question: 22

Which statement about the join process of the access point is true?

Refer to the exhibit.

A. The time on the controller is outside of the certificates validity time interval, so the join phase failed.
B. The AP moved from this controller to its primary controller.
C. The controller rejected most of the discovery requests from the AP because they were not received on the management interface subnet. The AP failed to join the controller.
D. The AP successfully joined the controller.
E. The AP failed to join because the self-signed certificate of the AP on the controller was not correct.

Answer: C

Question: 23

New Updated 300-370 Exam Questions 300-370 PDF dumps 300-370 practice exam dumps: https://www.dumpsschool.com/300-370-exam-dumps.html

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two)

A. show sysinfo
B. show udi
C. show inventory
D. show boot
E. show tech-support

Answer: AB

Question: 24

While reviewing Clean Air data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting?

A. informational
B. major
C. minor
D. warning
E. critical

Answer: D

Question: 25

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

A. rogue AP containment
B. RF detection
C. switch port tracing
D. wire detection
E. Cisco Prime Infrastructure location services

Answer: A

Question: 26

Which Cisco WLC debug command allows you to determine if the certification process is failing in the CAPWAP messages?

A. debug pm pki enable
B. debug cert events enable
C. debug capwap events enable
D. debug capwap packet enable
E. debug capwap errors enable

Answer: E