Cisco 400-351 Exam Preparation Questions – Pass With Guarantee

By | December 26, 2017

Cisco CCIE Wireless 400-351 exam preparation is now reachable without spending huge amount of money and time because the most authenticated comprehensive Cisco 400-351 exam dumps materials are available on 25% discounted price for ensured success. Cisco Certified Internet Expert Wireless 400-351 exam Practice test software enables you to practice for Cisco 400-351 exam with real exam scenarios to boost your confidence and to enable you attempt the Cisco exam with full confidence to pass.

400-351 exam questions, 400-351 PDF dumps; 400-351 exam dumps:: (274 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 400-351 Dumps Exam Questions and Answers:

Version: 15.0
Question: 21

You are the network administrator of a Cisco Autonomous AP deployment. You want to stop a client with MAC address 5057.a89e.b1f7 and IP address from
associating to your APs. Which configuration do you use ?
access-list 700 permit 5057.a89e.b1f7 0000.0000.0000
dot11 association mac-list 700
ip access-list 25 deny host
interface Dot11Radio0
ip access-group 25 out
interface Dot11Radio1
ip access-group 25 out
ip access-list 25 deny host
interface Dot11Radio0
ip access-group 25 in
interface Dot11Radio1
ip access-group 25 in
access-list 700 deny 5057.a89e.b1f7 0000.0000.0000
dot11 association on mac-list 700

Answer: D

Question: 22

Refer to the exhibit.

Which feature (and associated show output) is seen here?

A. Controller>show client tsm 802.11a 00:01:02:03:04:05 all
B. Controller>show client wmm 802.11a 00:01:02:03:04:05 all
C. Controller>show ap stats 802.11a00:01:02:03:04:05
D. Controller>show client detail 00:01:02:03:04:05

Answer: A


Question: 23

New Updated 400-351 Exam Questions 400-351 PDF dumps 400-351 practice exam dumps:

You are getting the following error message. Which reason for this issue true?
%DOT11-4-CANT_ASSOC Interface Dot 11 Radio0. Cannot associate NO Aironet Extension IE.

A. “dot11 extension ” is missing under the interface Dot11Radio 0 interface.
B. When repeater mode is used, unicast-flooding must be enabled to allow Aironet IE communications.
C. The parent AP MAC address has not been defined.
D. Repeater mode only works between Cisco access point.

Answer: A


Question: 24

You have received a new Cisco 5760 Controller and have gone through the initial startup wizard. You are now trying to add APs to the controller, but these are not joining.
Which three checks should you do next? (Choose three.)

A. Check that the radios are not in a shutdown state.
B. Check the country code of the controller. The APs do not join the controller if the country code does not match.
C. Check that the correct time is set on the controller.
D. Check that option 53 has been set in the DHCP scope.
E. Check that the controller has enough AP licenses.
F. Check that the controller has been configured with the correct hostname. Otherwise, DNS resolution fails.

Answer: BCE


Question: 25

You are installing Converged Access controllers that run Cisco IOS-XE and you are ready to implement QoS. From the below, choose all the possible QoS target levels that would apply to downstream traffic (toward the client)?

A. Client, SSID, Radio, Port
B. Client, SSID, Radio
C. Client, Radio
D. Client, SSID

Answer: A


Question: 26

Which memchanism incorporates the channel capacity into the CAC determination and gives a much more accurate assessment of the current call carrying capacity of the AP?

A. Static CAC.
B. Reserved roaming bandwidth(%).
C. Expedited bandwidth.
D. Metrics collection.
E. Load-based AC.
F. Max RF bandwidth (%).
G. Admission control.

Answer: E